Shadazzle Natural Wood Restorer — 500ml

Tired timber, back in one pass.

Dull cabinets. A dining table that has lost its depth. An outdoor setting that has gone grey over two summers. Shadazzle Natural Wood Restorer cleans, degreases, revives and protects — in a single wipe, with no sanding, no stripping and no harsh chemicals.

It is not a wax. Wax sits on top of timber and eventually goes sticky. This is a far finer formula that penetrates the grain, lifts the grime that is dulling it, and brings the original colour back while leaving a protective layer behind. It dries fast and leaves no streaks and no tacky film.

Made for every timber surface, inside and out

Indoors: tables, chairs, cabinets and fitted kitchens; parquet, hardwood and laminate floors; interior doors, window frames and trims.

Outdoors: decking and patios, garden furniture and benches, fences and gates — where it also lifts dirt and mildew and adds protection against moisture and UV.

Why this one

• Penetrates, does not coat. Finer than a wax, so it revives the timber instead of hiding it.
• Solvent-free green formula. Built on green solvents and biosourced surfactants, with no hazard pictograms on the pack.
• One product, every job. Clean, degrease, revive and protect in one step, indoors and out.
• Dries fast, no residue. Applies smoothly, no streaking, nothing sticky left behind.
• Made in France. Performance-tested, recyclable metal tin.
• Exclusive to Amarra DIY Hub. The only place to buy it in Australia and New Zealand.

500ml.

How to use

1. Dust or sweep the surface so it is free of loose dirt.
2. Shake the tin. Apply a small amount to a clean, dry cloth — less than you think.
3. Work it into the timber along the grain.
4. Leave it a few minutes to penetrate.
5. Buff with a second clean cloth for a soft, even finish.

On greyed or heavily weathered outdoor timber, a second coat after the first has dried gives a deeper result. Always test on a small, hidden area first.

FAQ

What timber can I use it on? All types — raw, oiled, waxed, varnished and laminate. Indoors and outdoors. Test a hidden area first.

Is it a wax or an oil? Neither. It is a fine restorer that penetrates the grain rather than sitting on top, which is why it does not go sticky.

Will it change the colour of my timber? It brings back the original colour that dirt and dullness were hiding. It is not a stain and will not darken bare timber.

How much do I need? A little goes a long way. One 500ml tin covers a large dining setting or a mid-size deck section with a second coat.

Is it safe to use indoors? Yes. Solvent-free, with no hazard pictograms on the pack and formulated without irritants or sensitisers — which is why it is fine in kitchens and bedrooms. Keep out of reach of children as with any cleaning product.

Will it remove water rings and marks? It lifts surface marks, water staining and grime. Deep scratches through the finish need refinishing.

How often should I use it? Indoor furniture: every few months. Outdoor timber: at the start and end of the warmer months.

How is it different from the Shadazzle clay? The clay is for hard surfaces — steel, chrome, glass, grout, tile. The restorer is for timber. Same natural approach, different job.